Lattice CrossLink LIF-MD6000 Master Link Board - Revision C, Руководство пользователя, Страница: 8 / 40

CrossLink LIF-MD6000 Master Link Board - Revision C
Evaluation Board User Guide
© 2018 Lattice Semiconductor Corp. All Lattice trademarks, registered trademarks, patents, and disclaimers are as listed at www.latticesemi.com/legal .
All other brand or product names are trademarks or registered trademarks of their respective holders. The specifications and information herein are subject to change without notice.
8 FPGA-EB-02018-1.0
3. Programming Circuit
The Mini-B USB connector is used for programming the board by using Lattice Diamond Programmer software.
Figure 3.1 shows the programming block of LIF-MD6000 Master Link Rev C board.
The Mini-B USB connector interfaces to the FTDI FT2232H IC. The FTDI IC works with Diamond Programmer software to
provide interfaces for:

JTAG – to program MachXO3 LCMXO3LF-1300E

SPI – to program CrossLink and/or SPI Flash Memory

I
2
C – to program CrossLink
USB Mini-B
(J2)
FTDI Chip (U1)
SPI Flash (U14)
LIF-MD6000
CSFBGA81 (U8)
LCMXO3LF-1300E
MG121 (U19)
JTAG
SPI
SPI/I
2
C
Figure 3.1. Programming Block
3.1. Bridging Circuit
Figure 3.2 shows the block diagram of bridging of different standard interfaces. The CrossLink device is used as a
bridging device that supports a variety of I/O standards. This demo board supports development of the following
interface bridges:

1:1 MIPI DSI Display Interface Bridge

1:2 MIPI DSI Display Interface Bridge

2:1 MIPI CSI-2 Image Sensor Aggregator Bridge

CMOS to MIPI CSI-2 Image Sensor Interface Bridge

MIPI CSI-2 to CMOS Image Sensor Interface Bridge

MIPI DSI to CMOS Display Interface Bridge

OpenLDI LVDS to MIPI DSI Display Interface Bridge

CMOS to MIPI DSI Display Interface Bridge