Latsen Technology Pawfit 2, Руководство пользователя

Страница: 6 / 37

Section 4 – How to charge Pawfit
When the battery level is lower than 15%, the tracker’s LED light will flash red every 10 seconds to
indicate the battery is low. You will also receive a low battery notification on your phone when the
battery level is lower than 15% to remind you to charge it too.
Pawfit charges best when you use a quality USB charger with an output no greater than 5v. A poor
quality USB charger cannot guarantee stable output and any sudden power surges may trigger the
protection unit to shut down the battery and in the worst case might damage the entire circuit.
Once your tracker is fully charged, the LED light will turn green. Remove the tracker from the
charger and press the power button for 3 seconds until you hear the “Welcome to Pawfit” message to
turn the tracker back on.
We strongly advise not over charging your tracker as this can shorten the life expectancy of its
battery. Do not leave charging once tracker is fully charged.
Section 5 – Turning on/off your Pawfit 2 tracker and confirming online status
Before you go out with your Pawfit 2 tracker, we always advise checking that it is switched on and
online. When the tracker is online, it means that it has connected to the 2g network and is able to send
and receive data to the Pawfit app.
5.1 – Switching your tracker on
To turn on your Pawfit 2 tracker, press and hold the power button for 3 seconds until you hear the
“Welcome to Pawfit” message.
5.2 – Checking the tracker is online
You can confirm the tracker is online by pressing the power button. If the status light flashes blue, the
tracker is online. If the light flashes red, the tracker is offline and is still trying to connect to a
network. Please allow at least 30 seconds for the tracker to connect to a network after it has been
turned on.
If your tracker is not connected to a network and there is sufficient 2g coverage, you will need to
move to a different location, ideally outside in open air, and restart the tracker. To restart the tracker,
you will need to press and hold the power button for 3 seconds to turn it off. Once the light goes off,
press and hold the power button again for 3 seconds to turn it on. When the tracker restarts, you will
hear the “welcome to Pawfit” message. Wait for 30 seconds and then press the power button. The
status light on the tracker should now flash blue. If not, wait a bit longer or try again in a new
location.
If you have tried multiple times without success, please feel free tocontact our support team.