Initial Set-Up
Tires and Wheels
3-15
9/27/19
Initial Set-Up
3
The factory setting is approximately 1
inch, and should be readjusted to meet
your needs. Do not allow the anti-scalp
roller to be on the ground constantly or it
will result in premature wear.
3.19 Tires and Wheels
1.
Check the air pressure in the rear drive
tires.
2.
Maintain rear wheel air pressure at 18 psi, or as needed to maintain level deck cutting.
3.
Check the air pressure in the front tires.
4.
Maintain front tire air pressure at 12 psi, or as needed to maintain level deck cutting
5.
Verify proper function of all mower deck wheels.
The wheels should turn freely without excessive side-to-side motion, and be free of
debris.
6.
Clean, adjust, replace, and grease as necessary.
7.
Check that each wheel swivels freely in the shaft pivot collar, and the bearings are in
good condition.
8.
Clean and grease the shaft collar assembly if a wheel does not swivel freely.
9.
Replace the bearings if necessary.
3.20 General Inspection
1.
Verify that all warning decals are in place, visible, and legible.
2.
Verify that all covers and safety devices are properly installed and secure.
3.
Check that the discharge chute is clear of debris, properly mounted, and in good condi-
tion.
4.
Inspect entire Articulator for loose or entangled parts, debris, obstructions, misplaced
tools, or any other possible safety hazards, equipment hazards, or projectile hazards.
CM0025-4
FIG. 3-13
