3 - Setting Up Your Machine
Page 03
3.2 - Installing the Leveling Feet
Set the machine down in its desired location and determine if the
machine is level, making sure that it does NOT rock in any direc-
tion. If it does, determine which Leveling Feet need to be adjusted
and whether they need to be adjusted up or down.
If adjustment is needed, start by loosening the four (4) nuts which
are accessed through the rear of the machine.
Next adjust the four (4) Leveling Feet by screwing them clockwise
to raise the or counter-clockwise to lower. After each adjustment
set the machine down completely to verify that the machine no
longer rocks. Continue adjustment as needed until the machine
sits securely in place. Tighten the four (4) nuts down to secure the
position of the Leveling Feet.
3.2.1
3.2.2
3.2.3
Leveling Feet
Base of the Machine
Nut
3.3 - Installing the Blade and Die
3.3.1
3.3.2
3.3.3
3.3.4
3.3.5
3.3.6
Remove the Pressure Foot assembly from the Pressure Foot Mount by unscrewing the threaded knob on the front
of the Pressure Foot Block. Pull the Pressure Foot Block straight out away from the machine to remove.
Using the 5/32” Hex Wrench, remove the two(2) hex screws for the Blade and the one(1) hex screw for the Die.
Insert the desired Blade in its position making sure the blade is positioned all the way up in the Blade Holder.
Tighten down the two(2) hex screws for the Blade until it is secure.
Insert the new corresponding Die facing the new Blade. Replace the hex screw for the Die but do not tighten
completely.
Press down on the Foot Pedal bringing the Blade all the way down. Position the Die so that it fits tightly against the
Blade. Tighten down the Hex Screw for the Die until it is secure.
Reattach the Pressure Foot by sliding the Pressure Foot Block back into place noting the holes in the Pressure
Foot Block must align with the two(2) pins on the Pressure Foot Mount. Insert the threaded knob and tighten down
until the Pressure Foot is secure.
Pressure Foot Block
Threaded Knob
Blade
Die
Pressure Foot
Pressure Foot Mount
The Blade must not come down on the Die, this will cause damage