Page
4
CP-2502/2503/2510/2511/2513/2520/2521/2523/2530/2533
LASKOMEX PPUH
, ul. D¹browskiego 249, 93-231 £ód, tel. (42) 671 88 00, fax (42) 671 88 88, e-mail: [email protected], http://www.laskomex.com.pl
JP1
100
136
124
K1
K2
K3
K4
K5
K6
M
J
G
K
D
P4
J
- +
K1
K2
K3
K4
K5
K6
M
J
G
K
D
J
Adjustment of gain the microphone track in the panel
If there is need, the sensitivity of the microphone track can be adjusted with potentiometer
P4 in the external panel or with potentiometer P2 (microphone) in the electronic cassette.
Only adjustment with potentiometer P2 in the electronic cassette is suggested. If results are
not satisfactory then adjustment with potentiometer P4 should be done (position of the
potentiometer hand wheel should be maximal).
Volume control in external panel
If there is need loudness of the speaker in the external panel can be adjusted with potentiometer
P1 in the electronic cassette adjusting strength of the signal coming from uniphones see
installation and usage manual of system CD-2502.
Jumpers settings.
Set properly jumper JP2 on the electronic panel plate (see figure 3).
Figure 3: External panel - setting the kind of used display and supplying camera
(only in video version) - in CP-2503.
Jumpers settings for video version panel:
Set properly jumper JP1 on the electronic panel plate (see figure 3).
Set properly jumper JP1 on the symmetrizator plate (
NOTE:
not applicable for CP-2530) -
see figure 4. Value of the chosen resistance should be adequate to wave impedance of the
used cable. Standard setting is 100 adequate for UTP cable (
NOTE:
for telephonic cables
ie. YTKSY o 0,5 mm set also 100 ).
Figure 4: External panel - setting output impedance in a panel in video version
- not applicable for CP-2530 and CP-25x3 panels.
Set properly jumper JP3 on the electronic panel plate (see figure 3).
JP3 camera and additional illumination on
JP3 camera and additional illumination off
JP1
JP2
JP3
JP1 continuous supplying camera - regardless of the jumper JP3
JP1 supplying camera while its illumination, according with EUc
parameter - provided switching jumpers JP3
JP2 3 segments display
JP2 4 segments display
