Page
3
CP-2502/2503/2510/2511/2513/2520/2521/2523/2530/2533
LASKOMEX PPUH
, ul. D¹browskiego 249, 93-231 £ód, tel. (42) 671 88 00, fax (42) 671 88 88, e-mail: [email protected], http://www.laskomex.com.pl
Mounting on the plaster.
Drill openings for mounting the panel casing (mounted on the plaster), place the frame (or
frames) in the casing mounted under the plaster and screw both elements by strut pins.
Connect the wires and fix the panel with keyboard by screws and rivets.
Panel with the tenants list assembly
Description should be done in any graphic program and printed on the paper seize 51x90mm
for CP-2502N panel and 65x60mm for CP-2530 panel. When printing mind the 4mm margin
on every paper edge.
Figure 1: Replacement of a sheet with a list of occupants:
a) in CP-2502N panel,
b) in CP-2530, CP-2533 panels
3. DIGITAL ENTRY PHONE SYSTEM CD-2502 ADJUSTMENT
The elements of entry phone system are preliminarily
adjusted
and, unless it is necessary,
the position of potentiometers
should not
be changed.
Figure 2: Position of the potentiometer P4 in the external panel - in CP-2502.
Loosen the mounting
screws and move the
frame towards the outside
edge of a panel
Slide the card with description
in the plate slot
a)
b)
Move the frame as
shown on the
drawing and tighten
the screws.
Remove plexi glass
plates
Dents on the frame left
side should be put in the
openings in a casing panel.
The frame should be
pushed so that screws are
inserted in frame openings
Place a sheet of paper
with a description between
the plates and put them
back in a panel
remembering that thin
plate should be placed at
the casing back side
Remove the frame by
lifting it slightly and then
moving towards the
outside edge of a panel
K1
K2
K3
K4
K5
K6
M
J
S
K
D
P4
J
-
+
