5. Installing and connecting the video doorphone components
Installing and connecting the MVC-7002 monitor
For easier installation, all the wires of the video doorphone can be run to a standard
cable box installed in the wall. Once mounted, the monitor should cover the whole box.
This will make it easier to install and mount the monitor.
- The monitor is mounted on a metal holding bracket fixed to the wall. To fix the bracket,
place it against the wall in the intended place of installation and mark holes for rawl
plugs.
- Drill the holes as market and fix the bracket to the wall using rawl plugs.
- Connect the wires to the J102 socket connector provided with the kit, as shown in the
diagram, by soldering them to the wiring system. Protect all soldered connections and
isolated portions of the wires against short-circuit with a shrinking sleeve or insulating
tape. Plug the connectors to the sockets.
- Mount the monitor on the holding bracket.
Installing and connecting the additional monitor
For connecting two MVC-7002 monitors to a single outdoor panel, run a separate power
supply (J100 socket) to the additional monitor and connect the two monitors. See Figure
4,5 and 6. Set jumper JP2 in the last most remote monitor from external panel.
JP2 - Matching impedance to the coaxial cable.
9
Rys 7. Connectors in MVC-7002 monitor
Pin to J102 socket
Pin to J103 socket
Pin to J100 socket
(power supply)
Pin to J101 to
electro-catch
red
+
black
-
red
audio
white
wideo
yellow
Vcc+
blue
masa
red
audio
white
wideo
yellow
Vcc+
blue
masa
Installing and connecting the BVC-7002 panel.
- Unscrew the screws holding the panel to the casing.
- Place the casing at the intended place of installation, make a 242x112x46 mm cut-
out in the wall, and run the wires of the wiring system to the cut-out (see Fig. 8b). The
camera lens should be placed at a height of approx. 150 cm (see Fig. 8a).
- Make a circular hole in the casing, pull the wiring system cable through the hole and
affix the casing to the cut-out in the wall (Fig. 8c).
- Connect the wires as shown in the diagram. Solder the coloured wires going from the
outdoor panel (see Figure 2 and 5) to the wiring system of the phone. Protect all soldered
connections and isolated portions of the wires against short-circuit with a shrinking
sleeve or insulating tape.
LASKOMEX PPUH, ul. D¹browskiego 249, 93-231 £ód, tel. (42) 671 88 00, fax (42) 671 88 88, e-mail: [email protected], http://www.laskomex.com.pl
Содержание Bastion Orion II
Страница 1: ...Bastion Orion II Video door phone set...
