- 8 -
5.
ASSEMBLY AND CONNECTING ELEMENTS OF VIDEO DOOR
PHONE
Assembly and connecting
MVC-6502 monitor
To facilitate the assembly, mount a standard cable box in the wall where the monitor
is to be mounted and insert the wiring of the video door phone. After the assembly, the
monitor should wholly cover the cable box. This will facilitate connecting and mounting
the monitor.
- The monitor is mounted on a metal grip screwed to the wall. To mount the grip, put it
at the wall where it is planned to be mounted and mark places for dowels.
- Drill openings in the marked places and mount the grip to the wall using the dowels.
- Connect the plugs (included in the set) for J100 and J103 sockets to the wiring in
accordance with the diagram, soldering them to the wiring. Secure the soldered places
and isolated wiring cables against short circuit using shrink wrap or insulation. Connect
the plugs to the sockets.
- Mount the monitor at the assembly jig.
Connecting an additional monitor
- In order to connect two MVC-6502 monitors to one external panel, power supply (J100
socket) should be connected in the additional monitor and the two monitors should
be connected using J102 sockets. J103 socket in the second monitor is not used. See
Figures 4 and 6.
Pin to J100 socket
(power supply)
Pin to J103 socket
Pin to J102 socket
(optional - connection
additional monitor)
Figure 8. Connectors in MVC-6502 monitor
J100
J102 J103
+Vcc
Gnd
+Vcc
Gnd
audio
video
+Vcc
Gnd
audio
video
red
black
red
black
white
violet
red
black
white
violet
Assembly and connecting the external panel.
- Twist off the screw mounting the panel and the housing.
- Put the housing in the assembly place, mark places and drill openings for dowels.
The camera lens should be located at the height of ca. 150 cm (see Figure 9a).
- Put the wire through the round opening in the housing and mount the housing to the
wall (Figure 9c).
