- 9 -
catch requires an additional ACV feeder. Mount the electro-catch in the gate or the door
as prescribed by the manufacturer. Then, in accordance with the diagram (Figures 5,6,7)
connect the wires (yellow and brown) in the external panel, feeder wires and electro-
catch.
6. OPERATING VIDEO DOOR PHONE
- By pushing the release button in the external panel, the doorbell signal in the monitor
will be activated and the monitor will switch on, displaying image from the camera (If
an additional monitor is mounted the doorbell signal and the image from the camera
will appear on two monitors).
- Push button (conversation - see Figure 1) to launch voice communication. In the
case of two monitors mounted, once the voice communication is launched on one
monitor, the other one switches off.
- Should the voice communication after launching fail to activate, the monitor will be
automatically switched off after ca. 1 minute.
- The conversation may last up to ca. 100s. After this time, the conversation is automatically
ended.
- To close the conversation push (conversation) button.
- It is possible to release the electro-catch at any time during the conversation by pushing
the button
on the screen. The electro-catch`s transmitter operates for up to ca. 5
s. Its operation period does not depend on the length of button pushing.
The electro-
catch is activated once the button
is released.
- The image from the camera may be activated on the screen at any time. In order to
do so push (conversation) button. Simultaneously with activating the camera, the
voice communication is established.
- Pushing the transfer conversation button during the voice communication will transfer
the conversation to the second monitor - the first monitor switches off, and on the
second monitor the doorbell sounds and the image from the camera is shown (no audio mode).
- In order to receive the transferred conversation push (conversation) button.
- It is possible to set volume, color and brightness on the MVC-7001 monitor (see Fig.1).
CAUTION!!
Screen have delay about 2sec. first you hear a sound of doorbell.
7. MAINTENANCE
Video door phone elements should be cleaned with a damp duster. Alternatively, use
preparations for plastic elements cleaning.
ATTENTION!
Do not use preparations including solvents or abrasive materials to clean the video door
phone elements, as their use may lead to permanent damage of the housing surface!
Figure 9. Assembly of external panel
View side
150cm
a)
b)
c)
d)
Содержание Bastion Apus
Страница 1: ...Video door phone set manual Bastion Apus...
