Rev.B 10/23
AR122ES
3
Controls
™
for Home App Controls
Oscillation Button
Press to Start/Stop the Oscillation function.
Power Button
Turn heater ON/OFF by pressing the Power Button.
Heat Mode Button
Heater can be adjusted to H3 (High), H2(Med) and H1(Low).
Timer Button
The timer can be set for up to 12 hours. 0.5 - 12.0 hours in
0.5-hour intervals up to 2 hours, 1-hour increments from 2
hours to 12 hours. Continue pressing the Timer Button to
reach the desired time setting.
This heater may be operated by the Manual Controls located on top of the unit, or by the Aria
App Controls on your Smart device. For a detailed description on how to pair your product to the
Aria for Home App, see Quick Pairing Guide.
Back Button
Timer Button
Power Button
Oscillation Button
Temperature
Control
LED Control Button:
(App Exclusive Feature)
Use this feature to enable
Night Mode. Night Mode
will turn OFF your device
Display and only show it
for 5 seconds if a button
is pressed.
Settings Button
Go to the settings
page to enable smart
speaker control and
device sharing.
Parts Included
1 Body
2 Support Base A
3 Support Base B
2
3
2. Lay the unit on a sturdy table for easier
base assembly. Push assembled
Base
onto
Body
of unit as shown.
Assembly
1. Align the slots on
Base A
with tabs on
Base B
.
Snap Together.
3. Hold the
Body
in place while turning the
Support Base Assembly
clock-wise
until it locks in place.
Wi-Fi Button
Press and hold the Wi-Fi button for five seconds to put the unit
into EZ pairing mode. The LED indicator will start to blink red
when you do this.
Note: If you need to use access point (AP) mode to connect your
product, press and hold the Wi-Fi Button for another five seconds.
The red LED will start to blink red, rapidly.
Base A
Base B
1
Heat Mode
Button
Auto Eco
™
Button (+)
Press to increase the desired room temperature.
Auto Eco
™
Button (-)
Press to decrease the desired room temperature.
Inline Power Switch
Before turning on heater, turn on the Inline Power safety switch
located on the rear of the unit. Switch on to enable power to
the heater.