Laski FZ 500/27, Руководство по эксплуатации, Страница: 24 / 37

2 4
Putting into Operation
Start the cuter only after its proper coupling to the hydraulic jib, the cutting head
should not be in contact with any object and there are no persons or animals
within reach.
- Connect the remote control.
- Install the remote control leads properly on the hydraulic jib so that the wires are
protected against any damage. Pay special attention to places with hinged joints and with
bending hazards or contingent contact with other elements.
- We recommend to lead wires along hydraulic hoses with respect to sufficient clearance
for bending etc.
- Install the remote control box in the cab within the operator's reach so that he can react
immediately for any emergency situation.
- Set the choke ON (first or cold start).
- While starting with the choke set the accelerator lever in the MIN position.
- Start the engine.
-
CAUTION !!! As soon as the engine is ON the cutting head starts turning.
-
Increase the engine idling speed and set the choke slowly in the OFF position.
-
Increase the speed continuously up to its maximum
- If you heard any strange noises or vibrations during its initial run turn off the cutter
immediately and contact the authorised service.
-
Do not leave the machine unattended.
At the first start there is more air in the intake manifold and on this account the engine may not
roar to life immediately when turning the switch key for the first time. Do not crank the engine
for a longer time than 10 sec. We recommend to use the choke before cold starting.
Be aware that the engine is equipped with a fuel pump which delivers the fuel at every
starting. Never fill the filter and the relevant manifold with the fuel. After a short crank make
sure if the fuel filter is filled with the fuel. You should see a darker fuel level in the filter body. If
the fuel is under 3/4 filter volume crank the engine with its switch key once more.
Keep an interval between two starts 30 sec. at least.
Putting out of Operation
-
reduce the engine speed