Manual: RTI PIKO Series
page 12 / 57
b. Connection through switch
Requirements:
Standard network switch
The computer must be set to a static IP address in the same address space than the RTI PIKO
laser(s), but it MUST NOT be the same IP address, for example 192.168.1.10 or 192.168.1.35 are
OK. See chapter 8.4.2.2. on how to set IP address for the PC properly.
In case of having more than one RTI PIKO laser in the local network, ensure to set a unique IP
address for each one of them. To do so, it is necessary that each laser is directly connected to
the computer as described in chapter 8.1.2.1. (a). After having set individual IP addresses per
laser, all lasers and the computer can be wired as shown below:
Switch
Ether
net cable
Ether
net cable
RTI PIKO laser 1
Computer
Ether
net cable
RTI PIKO laser 2
8.4.2.2. How to set a static IP address
a. Click on the Windows start button and navigate to your control panel, click on „Network
and Internet“ and find „Network and Sharing center“, click on it. There should be only one
active connection, otherwise deactivate the second active connection as it may lead to
irritations. Double click on the active connection name (after label „Connections:“)
b. The „Ethernet Status“ window opens. Click on „Properties“, and look for the „Internet
Protocol Version 4 (TCP/IPv4)“. Click and select „Properties“. The following window allows
for specifying a static IP address. Subnet mask is 255.255.255.0 (do not change).