Manual: RTI NEO SIX RGB 2
page 14 / 30
The range for offset is between 0 and 34800:
The range for gain is between 0 and 39949:
After completing the advanced settings a test is shown. If the key switch is on, interlock
closed and a valid DMX signal is present, the digital analog converter generates a signal
which is converted back via an analog digital converter and compared to the internal refe-
rence. The deviation is shown here.
For example: a deviation of -2 at 5Vdc full range with 16bit resolution results here in a de-
viation of 0.000152Vdc. Even a deviation of 10 (still <1mV) does not affect the precision of
the device. The deviation of the DAC can also reach values up to 50 without affecting the
overall precision of the device:
7.
Beam Block Panel
The Beam Block Panel is meant as additional protection to prevent laser emission, e.g. into
the audition area. To prevent laser emission please loosen the screws and slide the panel in
front of the beam outlets. Fasten the screws again. Loosen the screws, slide the Beam Block
Panel down and fasten the screws to enable laser emission.
Attention: Do not open or close the Beam Block Panel while the device emits laser
beams!
8.
Turn off
To turn off the device, switch the key switch to off and disconnect the power cable from
the mains.
