Laserworld Pro-1200 G, Руководство пользователя

Страница: 5 / 14

Manual 5 / 14
Revision: Apr-10

Lasersources: aircooled DPSS laser (blue with RGB models, green all models), laser diode (red with RGB
models)
 Laser class: 4
 Modes: ILDA, DMX 512, auto
 ILDA: ILDA standard Sub-D shaped 25pin connector
 Galvos: max 50k scanspeed (at 4°)
 DMX 512: 18 channels
 Patterns: 160
 Scanangle: set to ca. 40° optical (60° max)
 Input voltage: AC 110-120, 220-240V switchable
50/60Hz

Power consumption: 350W
 Size: 675 x 370 x 420mm (W x D x H)
 Weight: 30kg Laser, total: 55kg (with
flightcase)
 Operating temperature: 10°-35°C
 Loudness: <70db
Change scanner
1. Unscrew UK M6 screws and disconnect signal
cable.
2. Loosen M4 x 10 screw and remove galvo.
3. Insert galvo, reconnect and fix signal cable.
4. Rotate galvo to center projection. Fix galvo.
Adjustable mirror mounts
Loosen setscrews, then adjust with X/Y adjustable screws. Make
sure beam is centered on scanner mirrors. Adjust Z-screw
simultaneously Tighten setscrews.
Pro-700 RGB : use tool (screwdriver) and give slight blow with
hand, to adjust mounts.
When combining beams (RGY/RGB laser), first make sure the beams
are (roughly) on the same spot on the mirrors/dichros. Then use a
test pattern (e.g. rectangle) to do fine adjustment. For adjustments,
always turn output power down (if possible).
Troubleshooting
Problem Possible reason Damaged part Replacement
No power Fuse blown Fuse 09-00-3001-01
Power supply defective +-24V 16-03-0039-00
CPU defective IC 00-89C516RD-00
X and/or Y axis no
deflection
Scanner defective Galvo 15-01-2215-00
CPU defective IC 00-89C516RD-00
Control board defective Control PCB 26-2A-LT12V2-00
Power supply defective +-24V 16-03-0039-00
Scanner driver board defective Scanner driver board 26-2A-6800A-00
Laser dark or dim
Lenses / mirrors dirty Clean with alcohol
Laser diode defective Laser diode Inquire
Control board defective Control board 26-2A-LT12V2-00
Configuration / wrong mode Check configuration (see
paragraph control panel)
No output
Configuration / wrong mode Check configuration (see
paragraph control panel)
Control board defective Control PCB 26-2A-LT12V2-00
Power supply defective +-24V 16-03-0039-00
Display board defective Display 26-2A-YX2012DI-00
Pins 4 and 17 of the ILDA signal
not connected
See below
Laser does not switch to ILDA mode:
 The interface does not connect pins 4 and 17 (Interlock) of the ILDA signal. See interface manual
 The cable does not connect pins 4 and 17. Use a cable that connects pins 4 and 17.
 Use an adapter, that connects pins 4 and 17.