Manual: Pure Sapphire / Purelight high power
page 4 / 8
11. Never use dimmer, RC or other electroni-
cally switched sockets. Whenever possib-
le, do not use the laser projector together
with large appliances (especially fog ma-
chines) on the same mains!
12. Ensure
sufficient ventilation
and do not
place the device on any warm or heat ra-
diating surface. Especially the
ventilati-
on openings must not be covered
!
13. Ensure that device does
not get over-
heated.
Make sure that the device is not
exposed to spotlights (especially moving
heads). Heat of spotlights could overheat
laser in a little while and leads to a degra-
dation of performance.
4. Working on the device
1. Be sure that the mains plug is not connected to the power sup-
ply while installing or opening the device (e.g. for cleaning).
2. Take off all reflecting things like rings, watches etc. before
starting to work with or at the projector.
3. Only use non-reflecting tools to work on device.
4. Wear protective clothing (like goggles, gloves etc.) accor-
ding to laser power and wavelength of the laser.
5. Service notes
•
Moisture and heat can reduce lifetime of
the laser system dramatically and expires
any warranty claim.
•
Quick on/off switching of device can re-
duce durability of the laser diode drama-
tically.
•
Avoid concussions during transport.
•
To increase durability of your laser,
protect device against overheating:
-
Always ensure sufficient ventilation.
-
Do not face spotlights (especially mo-
ving heads) to the device.
-
Check temperature after approx. 30
minutes with each new installation.
If necessary install the projector at a
place with different temperature.
-
Keep the device dry. Protect it from
moisture, rain and damp.
-
Switch off device when it is not nee-
ded. Diodes are switched on and can
wear off even if there is no visible la-
ser output.
•
Open the device at regular intervals and
remove any dust, particularly around fans
and laser. Otherwise the risk of overhe-
ating is imminent and will void the war-
ranty.
•
If there are traces of fog fluid in the pro-
jector, clean it and change the position of
the fog machine.
•
As for troubleshooting, please check the
FAQ on our website www.laserworld.com
