Manual / Bedienungsanleitung: EL-400 RG / EL-700 GB
Version / Stand: Jun-13
Page / Seite 5 of / von 10
4
8
9
256
5
16
10
Mode switch
The address is the sum of all activated numbers, see the following example settings (the white
rectangle represents the position of the switch)
:
Addr
switch
addr
switch
1
65
17
113
The laser uses 9 DMX channels, so make sure that the next device uses an address that doesn’t
overlap with this range. E.g. when using address 1, make sure the next device uses at least address
number 10.
Channel
function
1
mode: 0-63 Laser off; 64-127 sound mode; 128-191,
automatic mode; 192-255 DMX mode
2
Patterns
3
Animation (not with all patterns)
4
strobe (with increasing speed)
5
Point speed
6
horizontal movement
7
vertical movement
8
Colour: 1-101 green and red; 102-199 red; 200-255 green
9
Reset: above 200 (shortly)
Please note, that not all effect channels work with every pattern.
Maintenance / cleaning
Always disconnect from the mains when the device is not in use or before cleaning it.
Open the device by removing screws along the top cover (front and back), remove the top cover.
Remove any deposits of dust, especially at the fan. Check for condensed fog fluid inside. If so,
clean and rearrange the position of laser and/or hazer.
Mirrors need cleaning when a “halo” is
noticeable around the beam or an unusual high amount of diffuse light can be seen inside the
device.
Clean the mirrors with window cleaner and a paper towel.
Never look directly into the light source. Always disconnect from the mains when the
device is not in use or before cleaning it.
