This document will show you how to check and align your LaserPro Spirt Series Optics. The first thing to
check the
alignment. Briefly the logic is to have a perfectly straight beam path from Mirror 2
current
(Back top left) to mirror 3 (Left end of X axis). From mirror, 3 to mirror 4 (the one in the lens carriage).
Mirror 0 is for the red beam. Mirror 1 only controls where the beam hits the lens. If mirror 1 is adjusted
incorrectly you may have
edges when vector cutting in x or y.
slanted
The first step is to check your machines alignment. We will check it in 4 places P1, P2, P3, and P4.
(Diagram 1)
Mirror 2
Mirror 3
P1
P2
P3
P4
Mirror 4
Back of Spirit Series
To start place a piece of tan masking tape, transfer tape, or small white label to back of mirror 3’s
housing. (Cover the hole the laser beam enters to get to mirror 3
)
, see Figure 2 on Page 3
Turn on the machine while holding down the
key on the Control Panel.
Auto Focus
Remember to always wear safety glasses while doing any open beam tests.
1
to do is
