LaserPro Mercury, Руководство пользователя, Страница: 5 / 13

It would now be a good time to remove the lid. Remove the 8 phillips head screws that hold the
lid to the chasse. There are two on each side
These are the two back screws
Tools required Philips and Standard Screw driver
Offset ratchet standard screw driver. I bought mine at OSH Sears sells them as
well as most hardware stores,
Disconnect 3 wire clips 1 Black and Orange
2 Black and Red
. (On older models the Black
and Red wires will be in the back right) The B&R
are the lids interlocks . The B&O is the Door Open
LED. You will need to locate and press the release
on these connectors and pull apart.
The Grey Ribbon cable going to the control
panel is snug. It pulls out by gripping the
connector, or cable at the connector, and
pulling down.
(1)
(2)
(3)
1
2
3
Remember to always wear safety glasses while doing any open beam tests.