LaserPoint PcPlug-R, Руководство по эксплуатации

Страница: 7 / 13

LaserPoint srl –
PcPlug-R Laser Power and Energy Meter - All Rights Reserved
6 -
7-
INSTALLATION
Connect the
PcPlug-R
electronics to the host PC device by a 9-pin, straight through, RS-232 cable with
female connector.
The
PcPlug-R
DB-9 female connector pin assignment is as follows:
The
PcPlug-R
power plug is a 2.1mm connector for a DC 5-12V supply (positive inside). Max 15V.
Current is < 60 mA.
8-
QUICK GUIDE TO MEASUREMENT
This section provides a quick guide to perform basic measurements with the PcPlug-R Sensor.
9.1- Get Started:
To start measurements simply follow this list of actions:
1-
Insert the RS-232 connector into the PC port.
2-
Run Serial Terminal SW or your own SW
3-
Set the personal instrument settings:
Select the Measurement Range, Zero the instrument, and choose between the Power or Energy measurement
mode. For detailed instructions please
refer to the
“PcPlug-R - RS-232 Communication Interface”
document.
4-
Verify the set wavelength:
Select the laser wavelength.
5-
Zero the instrument:
Resetting the zero value is a recommended action every time a PcPlug-R Sensor is used.
For detailed instructions please
refer to the
“PcPlug-R - RS-232 Communication Interface”
document.
6-
Start the measurement session:
Place the detector head in front to the laser source. The measured Power/Energy values will be promptly
displayed on the instrument screen.