LaserPerformance Cascais Fun, Руководство по монтажу

Страница: 13 / 22

Rigging the gennaker
13
C
A
S
C
A
IS
F
U
N
R
IG
G
IN
G
M
A
N
U
A
L
If you are using the gennaker,
thread the halyard through the
upper mast block just like you did
on chapter 6 for the jib, before you
step the mast.
Fit the gennaker sock with the
straps around the gennaker
hoop
and the small line to the
sock eyelet and the eyestrap
that holds the block under the pole.
1
2 3
Temporarily thread the gennaker
halyard through the cunningham
loop
.
4
Find the small gennaker auxiliary
block and tie it to the short line
with a bowline
. Then tie the
other end to the eyestrap .
Make sure the line is longer than 25
centimeters (10 inches). A short
line will cause the gennaker sheet
to rub against the blue middle seat
and wear it out.
5
6
Take the gennaker tack line that
comes out of the aft end of the
pole, thread it through the block
attached to the eye strap and then
to the small block
with a
bowline.
7
3
8
Tie the small yellow line that comes
out of the aft end of the pole and tie
it to the eyestrap
near the mast.
9
Take the gennaker halyard end that
comes out of the fore side of the
halyard block and tie it to the head
of the gennaker with a bowline
,
so that it looks like the picture after
hoisted.
10
1
4
2
6
3
5
7
3
8
9
10