Laser Jailer Maintenance Manual
00892-53-000
Page 5 of 16
Issue 2 30 January 2020
3
Installation
3.1 Laser Jailer Tile Description
The Laser Jailer tiles are made from a laminate material approximately 2mm thick.
Each tile has a two 300mm long interconnection leads attached. A rear view is shown below showing
the interconnecting leads and mounting spacers.
Figure 1. Tile showing Rear View
3.2 Laser Jailer Tile Fixing
The tiles are screwed to the mounting surface with M4 screws and 20mm tall spacers, the gap
behind being used for the interconnection leads between the tiles.
The tiles should always be screwed into place. Adhesives and tapes should not be used as a tile
which becomes detached may fall and cause injury. For small enclosures which may be made of
sheet metal the spacers may be fitted directly into the enclosure wall. For larger enclosures where
thicker wall material is used the tiles are often supplied in groups pre-assembled to larger panels
which may be screwed to the wall.
When tiles are replaced it is usual to leave the spacers fitted to the structure.
