14
EN
3
Slope mode
Do not release the pendulum lock or turn the transport
fastener (2) counter clockwise. Switch on the lasers
(buttons 12, 14). Sloping planes and tilts can now be
measured. The lasers flash once in a while to show that
the device is not aligning automatically.
1
2
Use of lithium-ion rechargeable battery
Before using the laser for the first time, insert the
battery in the device and fully charge (at least 4 hours).
Connect the battery charger to charge the battery.
The LED of the battery pack lights red while the battery
is charging. When the LED changes to green, charging
is complete. When the backlight of the circular level
flashes, the battery is low. In that case, recharge the
battery. The rechargeable battery can either be charged
when it is not inserted in the device or when the device is in use.
– The battery may only be charged with the battery charger provided
and used only in this laser device. Any other use may cause injury
or fire.
– Make sure there are no conductive objects in the vicinity of the
battery contacts. Short-circuiting of these contacts can cause burn
injuries or fire.
– Do not open the rechargeable battery. This could cause short-circuits.
!
Horizontal and vertical levelling
Turn the transport fastener (2) clockwise and release the pendulum lock.
The lasers are now automatically aligned by the pendulum system and
the horizontal laser lights constantly. The lasers can be switched on and
off individually with the H and V buttons. It is now ready for levelling in
the horizontal or vertical plane.
If the device is too far off the horizontal (more than 2°), the lasers will
blink. Align the device using the adjustable feet (7) or place on a more
level surface. The round vial (9) is provided as an aid to alignment.
!
