Single slope function
up to 5°
In automatic mode, an axis can be manually set to a certain slope using this function, even if the
ADS tilt function is also active. This means that one axis can be re-adjusted whilst the other is
aligned horizontally. Press the slope/man button to activate the function and select the X or Y axis.
The slope LED flashes, as does the LED for the X or Y axis. The slope is re-adjusted using the
plus/minus buttons. ATTENTION: This function cannot be used to perform full horizontal levelling,
just to adjust one axis.
Application example: A gradient is to be laid out at the entrance to a garage. For this, one axis must be
re-adjusted and the other aligned horizontally with the garage floor.
IMPORTANT: If a horizontal line is to be moved simultaneously on one wall, the X or Y axis of the rotary
laser must be aligned at right angles to the wall. If this is not done, a slope will be projected onto the
wall. Use the reference beam to set the right angle.
DuraMax / DuraMax XPro
Commander 50
1
± 5°
2
± 5°
4
3
X axis
Y axis
Constant
illumination
Constant
illumination
Constant
illumination
Constant
illumination
Slow
flashing
Constant
illumination
Constant
illumination
Slow
flashing
Constant
illumination
Slow
flashing
Constant
illumination
Slow
flashing
or
2x
optional
function
optional
function
16
GB
Manual_DuraMax_XPro_Rev.0910_A5.indd 16
Manual_DuraMax_XPro_Rev.0910_A5.indd 16
27.09.2010 17:06:33 Uhr
27.09.2010 17:06:33 Uhr