4
A1
A2
2.
1.
A3
A2
A2
A1
4.
3.
A3
A2
<
2 mm / 10 m = OK
10
GB
Hand receiver mode
Optional: Working with the laser receiver RX
Use an RX laser receiver (optional) to carry out levelling at
great distances or when the laser lines are no longer visible.
To work with a laser receiver, switch the line laser into hand
receiver mode with the Hand receiver mode button (6). The
laser lines will now pulsate with high frequency, making the
laser lines darker. The laser receiver RX can detect these
pulsating laser lines.
Follow the operating instructions of the corresponding laser receiver.
!
Performing the calibration check:
3.
Position the device as near as possible to the wall at the height of point A1.
4.
Turn the device through 180° and mark point A3. The difference
between points A2 and A3 is the tolerance.
Preparing the calibration check:
It is possible for you to check the calibration of the laser. To do this, position the device
midway
between 2 walls, which must be at least 5 metres apart. Do this by turning the unit on, thus
releasing the transport restraint (cross laser on). Please use a tripod.
1.
Mark point A1 on the wall.
2.
Turn the device through 180° and mark point A2.
You now have a horizontal reference between points A1 and A2.
When A2 and A3 are more than 2 mm / 10 m apart, an adjustment is necessary.
Contact your authorised dealer or else the UMAREX-LASERLINER Service Department.
!
Та
ше
в
-
Га
лв
ин
г
ОО
Д
www.tashev-galving.com
