LaserLine GL3000PM, Руководство пользователя

Страница: 6 / 11

5
USING THE GL3000PM LASER
USING THE GL3000PM
1. Turn on the Main Power Switch about10-15 minutes
prior to use. This puts the laser module in the “preheat”
mode to bring it up to operating temperature. The laser
mode power status light will slow-blink while it’s warm-
ing up.
Once the laser power status light stops blinking
and goes out the laser will be ready to turn on — push
(3) Laser Mode Switch once for on steady, push twice
for on blinking—third push shuts off the laser.
2. Place vehicle at your desired location on the road.
3. Aim the laser spot to the desired reference point on
the road; i.e. existing centerline stripe, road edge, etc.
Once you have located the laser spot as your reference,
as you are driving the spot will indicate your position
relative to “on” center. If you are moving too far to the
right, the laser will be to the right of your reference. If
you are moving too far to the left, the laser will be to
the left of your reference. The laser spot is designed to
be used as a reference about 15 to 35 feet in front of the
vehicle. The laser spot reference on the road usually
appears the brightest at this distance.
4. The laser spot reference ahead of you is more visible or
less visible depending on conditions such as the surface
you are driving on and the brightness and location of
the sun. One of the worst conditions is driving into low
sun on new asphalt. This creates a condition where the
surface looks almost white from all the glare.
If laser spot becomes hard to see:
· Bring the laser spot closer to the truck
· Operate the laser in the “blink mode”.
· Wear the “laser enhancement” glasses.
5. Laser Enhancement Glasses (part number 3000-0435)
block out glare and increase laser spot visibility for the
driver in daylight operations.