CHAPTER 4
OPERATION
4-2
DT-203P, DT-105P and DT-110P display series
4.3.1
Enter to modify parameters.
In order to enter the sequence to modify the parameters, the Advance key “*” must be pressed
and held for three seconds. After this, the first parameters will be displayed, with the digit flashing.
There are then two options:
Modify the parameter value
By pressing the Advance key "*", entry is gained to modify the parameter value.
To go back to displ
aying the parameter number, press “*”again.
To increase the parameter value, press the “+” key. After parameter EXIT it returns to
parameter LANGUAGE.
Select another parameter
In order to select another parameter, the parameter number must be made to flash using the
“*” key and then the new parameter may be selected using the “+” key.
4.3.2
Exit modify parameters.
In order to exit the sequence for modifying parameters, parameter EXIT must be selected then
press "*".
4.3.3
Function of each parameter.
4.3.3.1
Parameter LANGUAGE or LA.
The language menu. There are four languages available: Catalan, Spanish, French and
English.
4.3.3.2
Parameter ADDRESS.
The network display address. Selectable between 0 and 299. Depends of each protocol
4.3.3.3
Parameter PROTOCOL or PR
The selected protocol. The protocols available are: TDL
4.3.3.4
Parameter BAUD RATE
Selects the transmission baud rate. There are three baud rates available: 4800, 9600 and
19200.
4.3.3.5
Parameter DATA LENGHT
Selects the transmission data length. Select 7 o 8 bits
4.3.3.6
Parameter PARITY
Selects the parity transmission parity. Select Even, Odd or None.
4.3.3.7
Parameter STOP BITS.
Selects the transmission number of stop bits. Select 1 or 2.
4.3.3.8
Parameter SERIAL INPUT.
Selects the transmission type of serial line: RS-232 or RS-485
