PTB-1-WR
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
6
WIRELESS REMOTE TRANSMITTER PROGRAMING PROCESS
Disconnect the cigarette jack (Y-Pin Connector)
Make sure there are NOT any transmitter operations within 3 meters while programming
Plug in the cigarette jack (Y-Pin Connector) and connect power supply
Within five seconds, turn power on and press the transmitter’s upper button
and down
button
at the same time. The lamp will flash once, which means it accepts the first
transmitter.
If you like to program the second transmitter (one lamp accepts three transmitters at most),
within five seconds, after the first transmitter completed its program process press the second
transmitter’s upper button and down button at the same time. The lamp will flash
twice to accept the second transmitter.
If no action is taken for five seconds, the lamp will leave programming mode.
ATTENTION:
If you would like to use the original transmitter, you should program it during the
same programming process with the new ones, or the original transmitter will be unavailable.
