Page 3 of 3
Rev 05117
Note:
When removing an attached magnetic antenna from the mounting
plate, do not force the device off the front causing the mount to bend as this
could cause strain to the mount and tail light. Instead, remove the magnetic
device from the front of the mount, up and towards from you.
ROUTING WIRE THROUGH GASKET
It is recommended to use wire no thicker than gasket width (4mm). Only cut and route wiring through the
bottom of mounting plate and gasket. This limits water from entering the taillight area.
1.
Find an area on the bottom of gasket to route wire.
Water has greater potential to enter taillight area if
gasket is cut from the top or sides.
2.
Press cable up against gasket to create an indentation.
Mark gasket with other device if necessary.
3.
Cut gasket to size using indentation or marked area. Cut
slightly smaller for a tighter fit and remove excess foam.
4.
Test wire for fit. Cut any additional foam if necessary.
5.
Once the wire fits, connect to power source and install mounting plate with wire routed through
bottom of gasket.