LEDWL-STRB-RED-1227
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
2
of
3
The LEDWL-STRB-RED-1227 LED warning/indicator strobing spotlight is equipped with Deustch connector and a 20` wiring harness.
The external power supply is remote mountable. Operators can install the power supply between the light and the control station. The
external power supply is designed to be hardwired and operates on voltages ranging from 120-240V AC.
Warning:
Check product label for correct input voltage!
Attach supply line wires to the appropriate light fixture wires as shown
in the diagram
Secure each pair of wires according to the diagram. Utilize a junction box or
similar device and take precautionary steps for weatherproofing all
connections if installed in a location where water may come in contact with the
unit. Ensure the unit is properly grounded and that wiring is done according to
all local and national electrical/building codes.
Standard Cord Cap
This unit comes pre-wired from factory with the selected cord cap. Take
precautionary steps for weatherproofing all connections if installed in a
location where water may come in contact with the unit. All outdoor
installations and indoor installations near a wet location require the use of a
GFCI device for safety, according to the National Electrical Code® (NEC).
Ensure the unit is properly grounded.
DETACHABLE CORDS
•
Cord is attached via a weatherproof 2-pin Deutsch connector.
•
The cord is detachable by depressing the tab on the top of the connectors. This enables the
operator to remove and store the light while leaving the cord connected to the power source.
•
Additional or replacement cords can be ordered from our website. Contact us or visit LarsonElectronics.com for more
information.
PIVOT
ADJUSTMENT
BOLT
TIGHTENING BOLT
FIGURE 1
MOUNTING AND ADJUSTMENTS:
The LEDWL-
STRB
is suspended within a form fitting trunnion
(yolk-type) mount. This trunnion mount allows the LED light to
be adjusted into any position once mounted. Simply loosen
the Pivot Adjustment Bolt shown in
FIGURE 1
, angle, and
tighten once desired position is achieved.
A single stainless steel tightening bolt protrudes from the
mount, enabling the operator to install the light using a single
through-hole.
This LED warning spotlight comes in a variety of output
colors from factory. Colors shown in this manual may vary.
