LED25WRE-LENSCOVER
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
2
Snap on Polycarbonate Lens for LED25WRE Round LED Light Fixtures -
Multiple Colors - Spot/Flood Lens
These snap on lenses fit over the face of the LED25WRE round LED
light fixtures. These snap on lenses are offered in clear, blue, amber, and
red color options and in euro, spot, flood, elliptical, and wide flood beam
configurations. Each lens is constructed of scratch resistant
polycarbonate and is designed to snap onto the front of the light fixture.
Please note, these lenses are designed for the LED25WRE.
Clear lenses diffuse the light without changing the color. In the spot
configuration, the clear lens is used to protect the face of the light fixture.
Blue lenses are best suited for snow and arctic conditions. Operators will
experience less glare and reflection from the snow, and will be more
noticeable to oncoming traffic.
Amber lenses are best suited for fog and water environments. The
amber color penetrates the fog better than higher color temperatures,
reducing glare and increasing visibility under high fog conditions.
Red lenses are best suited for dust. The red color pierces through the
dust and improves visibility where other colored light sources may
provide low to zero visibility.
INSTALLATION
•
Disconnect fixture from power and ensure it is cool to the touch.
•
Remove the old lens and replace with desired new replacement lens.
•
Reconnect fixture to power and continue use.
MAINTENANCE
There are no serviceable parts inside the fixture. However, it is good practice to routinely clean and check the
fixture for proper function.
•
Disconnect power running to the lamp and be sure the fixture is cool to the touch.
•
Use a non-abrasive glass cleaning solution to clean the lens.
USE AND CARE
Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.
Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of
children when not in use. Inspect for good working condition prior to storage and before re-use.
REPLACEMENT PARTS
The
LED25WRE-LENSCOVER
is designed to provide years of reliable performance. Should the need for replacement
parts arise, please contact Larson Electronics.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.
SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.
