Larson Electronics LLC www.LarsonElectronics.com [email protected]
9419 E US HWY 175, Kemp, TX 75143 - P: (800) 369-6671 - F: (903) 498-3364
3.
Tighten the pressure plate screws.
4.
Install the poletop slip-fitter onto a 1 – ½” or 2” pole. Tighten the three locking bolts.
5.
Mount the luminaire with yoke to the poletop slip-fitter using the mounting bolt (supplied).
Tighten the mounting bolt in place.
Optional Poletop Slip-Fitter
Note:
Flexible cord or cable shall be used for extra hard, wet locations and have a temperature rating as
indicated on the luminaire nameplate. The cord/cable should have a diameter between ½” and 5/8” (13
mm-16 mm). Cords/cables outside of this range may prevent the proper functioning of the pressure
plate and cord grip assembly, and may result in water ingress.
1.
Loosen the two screws on the pressure plate for cord/cable entrance.
2.
Feed the supply cord/cable up through the poletop slip-fitter and out through the cord grip
assembly. Leave at least 10” (254 mm) of slack to make connections inside the luminaire.
NOTE:
#16 AWG (1.5 mm) cord/cable is recommended.
3.
Tighten the pressure plate screws.
4.
Install the poletop slip-fitter onto a 1 - ½” or 2” pole. Tighten the four locking bolts.
5.
Mount the luminaire with yoke to the poletop slip-fitter using the two luminaire mounting bolts
(supplied). Tightly secure the bolts.
Pendant Mounting
This LED luminaire has a conduit entry (3/4” NPT) located on the back of the luminaire for pendant
mounting.
1.
Thread the luminaire onto a ¾” NPT conduit stem.
Note: A brace is required on conduit stems longer than 12 inches (NEC Requirement).
2.
Tighten down the external set screw to secure in place.
