HAL-16C-185LED-CPR-100
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
2
The Larson Electronics HAL-16C-185LED-CPR-100 hazardous location LED light cart provide operators
with a powerful and energy efficient alternative to other hazardous area luminaries such as high pressure
sodium (HPS), metal halide (MH), and halogen lights. LED technology and a sturdy design make this light
perfect for a wide variety of illumination needs. The durable wheelbarrow cart design can be adjusted for
angle and provides a sturdy and rugged stand for portable illumination, temporary hazardous area lighting,
and other hazardous location lighting needs.
WARNING
To avoid the risk of fire, explosion or electric shock, this product should be installed, inspected and
maintained by a qualified electrician only, in accordance with all applicable electrical codes.
To avoid electric shock:
•
Be certain electrical power is OFF before and during installation and maintenance.
•
Luminaire must be connected to a wiring system with an equipment-grounding conductor.
To avoid explosion:
•
Make sure the supply voltage is within the luminaires’ voltage rating.
•
Ensure the marked T rating is less than the ignition temperature of the Hazardous Atmosphere.
•
Do not operate in ambient temperatures above those indicated on the luminaire nameplate.
•
Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.
The light fixture on this wheelbarrow cart is factory sealed.
CART OPERATION
The wheelbarrow cart assembly consists of 2 parts:
1.
Light head
2.
Wheelbarrow cart base
To assemble cart, insert light head over center hole of wheelbarrow cart and tighten hand screw. The
wheelbarrow cart is now ready for use.
Tilt cart using both handles and maneuver like a wheelbarrow. Simply roll entire assembly to a new location
once assembled. Make sure light head is secure prior to maneuvering cart.
WARNING:
Be sure all hand screws are tight before transporting! Use caution when maneuvering near
inclines or drop offs.
Run power cord to a nearby receptacle outputting voltage listed on product label.
WARNING:
check nameplate for proper voltage. Damage from improper voltage may void warranty.
To adjust light head vertically, loosen hand screws on either side. Once desired angle is achieved, tighten
both hand screws to secure light in its place. Loosen the single hand screw holding light head to rotate
horizontally.
Be sure all hand screws are tight before transporting!
185 Watt Hazardous Location LED Light - Wheelbarrow Cart - C1D2 -
ATEX - 100 foot Cord w/ EXP Plug
Instruction Manual