![background image](http://html.mh-extra.com/html/larson-electronics/golight-radioray-gl-7-gt-series/golight-radioray-gl-7-gt-series_instruction-manual_676955002.webp)
GL-7XXXGT Series
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
4
BATTERY INSTALLATION – WIRELESS HANDHELD REMOTE
1. Remove the battery compartment cover from the rear of the handheld remote by removing the single rounded head
screw.
2. Insert the two supplied 23A 12V batteries. Note batteries must be installed with proper polarity (+ and - ) as shown
inside battery compartment. See Figure 2.
Figure 2
3. Reinstall battery cover and screw.
REPROGRAMMING – WIRELESS HANDHELD REMOTE
The RadioRay handheld remote is pre-programmed to the spotlight using
a default setting at the factory. Golight recommends reprogramming the
remote to the spotlight to prevent cross-talk with other spotlights in your
fleet or in your area. Reprogramming simply involves changing the DIP
switch settings inside the remote
and the spotlight will re-learn the new
channel. There are 2187 possible channels.
Figure 2 - Wireless Handheld Remote
1. Disconnect power to the spotlight.
2. Remove battery cover from the handheld remote.
3. Set the seven DIP switches (See Figure 3) to the selection of your
choice using a small flat screwdriver. Note each switch has positive
and negative settings with neutral in the middle. Note the orientation of
the positive and negative settings may vary between the wireless
handheld and wireless dash mount.
4. Replace battery cover.
5. Depress the on/off button and hold it down while reconnecting power
to the spotlight.
6. Release the on/off button after 6 seconds.
OPERATION OF GOLIGHT RADIORAY
1. Slide the spotlight into the magnetic or permanent mount shoe.
2. Insert the cigarette plug from spotlight into the vehicle 12V DC socket.
3. Using the remote, turn on the light by depressing the on/off button.
4. With the 4-way arrows on the remote, rotate or tilt your spot-light to the desired position. Depending upon conditions,
the wireless remote may be used up to 80 feet from the spotlight.
5. The speed of the light rotation or tilt can be controlled by depressing the tortoise/hare button one time and by
depressing it again to restore the original speed.
BATTERY REPLACEMENT AND DISPOSAL
1. See instructions above for battery installation in the handheld and dash mount remotes
2. Remove old batteries by gripping the positive end of each battery and lifting.
3. Batteries must be installed with proper polarity (positive and negative) as shown inside battery compartment.
4. Properly dispose of used batteries at your local recycling center.