Larson Electronics EXPCMR-CER-IP-POE-4MP-IR-V3, Руководство пользователя, Страница: 43 / 61

36
3. Click and drag the mouse to set a detection area.
4. Set the detection sensitivity, object size, and history for the camera to decide whether to report a
motion detection alarm.

Moving the slider to the right increases detection sensitivity. When the extent of motion
within the detection area exceeds the set object size, and if the duration of motion exceeds
the set duration, the camera reports an alarm.

Object size means the ratio of the size of the moving object to the size of the whole detection
area. So, if it is the small objects that you want to detect, it is recommended to draw
separate detection area(s) according to the actual motion area.

Motion detection results are shown in real time. The red lines represent the raised motion
detection alarms. The longer a line, the greater the extent of motion. The denser the lines,
the greater the frequency of motion.
5. Set the alarm parameters.

Suppress Alarm(s): After an alarm is triggered, the same alarm will not be reported within
the set time.

Clear Alarm(s): After an alarm is triggered,
A. If the same alarm is not triggered within the set time, the alarm will be cleared and the
same alarm can be reported again.
B. If the same alarm is triggered within the set time, the alarm will not be cleared until the
suppress alarm time expires. Then the same alarm can be reported again.
6. Set actions to be triggered by motion detection alarm and the plan.
The following table describes the major alarm-triggered actions and how to set a plan.
Item Description
Recording
Storage
With Recording Storage enabled, the camera automatically starts recording
after an alarm is triggered.
NOTE: Make sure you have completed the post-recording time settings before
using this function.
Upload to
FTP
With Upload to FTP selected, the camera will automatically upload snapshots to
the specified FTP server when an alarm is triggered.
NOTE: Make sure you have completed FTP and
Snapshot
before using this
function.