Larson Electronics LLC WWW.MAGNALIGHT.COM
9419 E US HWY 75, Kemp, TX 75143 - P: 903-498-3363 F: 903-498-3364 E:
Handle the battery carefully. Never allow it to short circuit. It can deliver hundreds of Amperes of current and
cause a fire.
CHARGE RACK AND CHARGING
To release the Lantern from the rack, squeeze the on-off switch of the Lantern and lift the Lantern up
and out of the Charge Rack.
To charge the Lantern, simply place the Lantern into the Charge Rack. It automatically locks in place and
starts charging.
CHARGE RACK MOUNTING
The charge rack is mounted by removing the 2 mounting screws at the top of the charge rack and sliding the metal
mounting bracket off the charge rack, then using 4 screws or bolts, attach the metal rack to the desired surface, then
slide the charge rack on to the metal mounting bracket and replace the 2 mounting screws in the top of the charge rack.
POWER SUPPLY
1.
Never directly wire any Charge Rack directly to any 120 volt AC power source. It is intended for 12-15 volt DC
only.
2.
Make sure that the installation is fused. 2 amps per unit are recommended.
LAMP REPLACEMENT (FOR GX2 Model Only)
Before replacing the halogen bulb, make sure it is cool before touching. Use of gloves and safety glasses are
recommended while changing the bulb.
To remove the lamp, unscrew the lamp ring by rotating the ring counter clockwise.
Then pull the reflector assembly out of the lantern and unscrew the lamp socket from the reflector.
Pull the bulb straight out of the lamp socket.
Repeat the procedure in reverse to replace the bulb.
VEHICLE POWER REQUIREMENTS
Maximum ampere draw from a completely discharged lantern is 2 Amps for the first 10 hours and 35 Amps from then
on. Nominal charging current is 1 Amp.
USAGE TEMPERATURE
-24°C (-11.2°F) to +44°C (+111.2°F)
