EPLC2-MB-100LED-100
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
3
of
4
To avoid electric shock:
Be certain electrical power is OFF before and during installation and maintenance.
Luminaire must be connected to a wiring system with an equipment-grounding conductor.
To avoid explosion:
Make sure the supply voltage is within the luminair
es’ voltage rating.
Ensure the marked T rating is less than the ignition temperature of the Hazardous
Atmosphere.
Do not operate in ambient temperatures above those indicated on the luminaire nameplate.
Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.
MOUNTING
This explosion proof LED light fixture is comprised of a 16x14 inch LED light head mounted atop a legged base stand fabricated
from non sparking aluminum, with a separate shelf type magnetic mounting bracket that allows mounting to ferrous
metallic surfaces. The lamp can be easily adjusted up or down 90 degrees and locked into position by simply loosening
the two T-handle adjustment screws located on either side of the light head and retightening them once the desired angle is
found. Included with this LED light is 100 feet of SOOW cord terminating in an 1523 explosion proof straight blade plug.
The magnetic mounting bracket for this unit includes six 200 lbs. grip magnetic bases which provide a total of 1,200 lbs. of grip
and allows operators to mount the unit to walls and flat metallic surfaces. Users simply attach the magnetic mounting bracket to
the desired surface, then hang the lamp assembly from the bracket.
WARNING:
If there is moisture present, or chance of it, in the conduit system then necessary
precautions should be taken by the installer to prevent the moisture from entering thr
ough
the
cable or conduit and entering the
fixture. Failure to comply with the above could void the warranty.
WIRING
(see attached wiring diagram)
This unit comes
equipped with 100 feet of SOOW cord terminating in an 1523 explosion proof straight blade plug. This plug
must be used with a compatible explosion proof receptacle to maintain the explosion proof rating of this fixture
.
WARNING:
CHECK NAMEPLATE
FOR PROPER VOLTAGE. DAMAGE
FROM IMPROPER VOLTAGE WILL
VOID WARRANTY.
MAINTENANCE
Caution:
To avoid personal injury, disconnect power to the light and allow the unit to cool down before
performing maintenance.
Warning:
No user serviceable parts inside of fixture. Risk of electric shock. Removal of the lens will void
the warranty.
1.
Perform visual, mechanical and electrical inspections on a regular basis. We recommend routine
checks to be made on a yearly basis. Frequency of use and environment should determine this. It is
recommended to follow an Electrical Preventive Maintenance Program as described in NFPA 70B:
Recommended practice for Electrical Equipment.
2.
The lens should be cleaned periodically as needed to ensure continued photometric performance.
Clean the lens with a damp, non-abrasive, lint-free cloth. If not sufficient, use mild soap or a liquid
cleaner.
3.
Inspect the cooling fins on the luminaire to ensure that they are free of any obstructions or
contamination (i.e. excessive dust build-up). Clean with a non-abrasive cloth if needed.
4.
Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.