EPL-HB-150LED-RT-NSF
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
2
1.
Using four bolts, washers and the four nuts provided, attach brackets “A” to both sides of bracket
“B”.
2.
The LED fixture has 9 holes for a versatile mount option. Select the holes that you would like to
use.
3.
Brackets “A” will then be bolted to the LED fixture with the remaining bolts and washers.
4.
The fixture is now ready for installation.
5.
A safety cable and eye bolt are included for additional safety.
WIRING
(see attached wiring diagram)
This unit comes preconfigured in the selected voltage, beam angle, and color temperature. Wire light
to the correct voltage. Follow all applicable local, state, and National Electrical Code for the
hazardous area!
POLYCARBONATE LENS
There are 8 clips holding the lens in place. Each clip snaps in place on the fixture holding the lens.
The lens can be removed if necessary for replacement. Refer to
EPL-HB-150LED-RT-188
instructions.
MAINTENANCE
Caution:
To avoid personal injury, disconnect power to the light and allow the unit to cool
down before performing maintenance.
Warning:
No user serviceable parts inside of fixture. Risk of electric shock. Removal of the lens
will void the warranty.
1.
Perform visual, mechanical and electrical inspections on a regular basis. We recommend
routine checks to be made on a yearly basis. Frequency of use and environment should
determine this. It is recommended to follow an Electrical Preventive Maintenance Program
as described in NFPA 70B: Recommended practice for Electrical Equipment.
2.
The lens should be cleaned periodically as needed to ensure continued photometric
performance. Clean the lens with a damp, non-abrasive, lint-free cloth. If not sufficient, use
mild soap or a liquid cleaner.
3.
Inspect the cooking fins on the luminaire to ensure that they are free of any obstructions
or contamination (i.e. excessive dust build-up). Clean with a non-abrasive cloth if
needed.
4.
Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS. SHOULD FURTHER
INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
OR BY PHONE AT
1-800-369-6671 FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.
WARNING:
CHECK NAMEPLATE
FOR PROPER VOLTAGE. DAMAGE
FROM IMPROPER VOLTAGE WILL
VOID WARRANTY.
Brackets “A”
Bracket “B”
Trunnion Bracket
