![background image](http://html1.mh-extra.com/html/larson-electronics/epl-16bs-1x150led-x24i-c1d1-200/epl-16bs-1x150led-x24i-c1d1-200_instruction-manual_3723759002.webp)
EPL-16BS-1X150LED-X24I-C1D1-200
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
2
PLUG OPERATION
Electrical connection between plug and receptacle is accomplished after plug fully inserts into receptacle and is
rotated clockwise.
1.
Locate polarization on mating plug pin and receptacle face. Insert plug straight
all the way into receptacle until it cannot go further.
2.
Rotate plug clockwise limit (37º), this closes internal contacts and completes
circuit. This also mechanically locks plug into receptacle so it cannot be pulled
out.
3.
To remove plug, push plug inward and turn to counterclockwise, pull plug
straight out.
MAINTENANCE
It is recommended that you implement a standard monthly or more frequent preventive maintenance
schedule. Safety requires a thorough visual examination of the unit for physical damage that might cause a
spark or result in the ignition of hazardous atmospheres.
Maintenance includes a careful examination to ensure at least:
A.
The Light Body is not cracked, broken or breeched.
B.
The Lens is not cracked or chipped.
C.
The Cable is not frayed and is gripping tightly in all points of cable contact.
D.
The Cable Jacket is completely intact and that no internal conductors or conductor insulation is
exposed.
E.
The Connection Box is not cracked, broken or breeched.
F.
The Cord Plug is not cracked or damaged and the Ground Post is intact.
For your safety and to maximize the life of the light, avoid rough usage such as:
A.
Pulling the Light by the Cable, which could weaken or damage the cable.
B.
Impacting the lens with hard, sharp or heavy objects, which could cause the lens to
scratch, chip, crack, or shatter.
C.
Disconnecting the Cord Plug from the receptacle by pulling on the Cable.
Keeping the light clean and free of material splatter, overspray, and debris during usage will ensure
the maximum life and luminosity of the light.
TROUBLESHOOTING
Refer to the guide below or contact the manufacturer if the fixture does not function properly.
Is the correct line voltage being supplied to the fixture?
Is the fixture properly grounded?
Make sure installed power switch is functioning properly (if applicable).
These instructions may not cover all details or variations of this product for your equipment or installation
requirements. Should further information not covered by these instructions be required, please contact
Larson Electronics at 1-800-369-6671 for further assistance.
Please visit LarsonElectronics.com for
Warranty
and
Return
information.