LT-4100 User & Installation Manual Rev 1.00
Installation and Mounting
Lars Thrane A/S
www.thrane.eu
Page 19 of 129
Pole Mount
(1.5” pipe, Ø38.8mm)
, Antenna Unit
The Pole Mount (1.5
” pipe, Ø
38.8mm), Antenna Unit is illustrated in Figure 18 to Figure 20.
Pole mount installation procedure:
1.
Feed the coaxial cable through the pole mount
2.
Fasten the coaxial cable to the LT-4130 Antenna Unit (N connector)
3.
Apply self-volcanic tape on the N connector and cable to protect against saltwater and corrosion
4.
Screw the pole mount (clockwise) on the LT-4130 Antenna Unit, and fasten the antenna lock pinot
screw, as illustrated in Figure 20 (max torque = 1.2 Nm)
5.
The LT-
4130 Antenna Unit and pole mount can now be mounted on the 2.0” pipe. Fasten the three
pole lock pinot screws, as illustrated in Figure 19 (max torque = 4.5 Nm)
NOTE
:
Remember to fasten the antenna lock pinot screw (1.2 Nm) after the pole mount and
antenna unit have been screwed together.
NOTE
:
Remember to fasten the antenna lock pinot screw (1.2 Nm) after the pole mount and
antenna unit h
ave been screwed together. The Pole Mount (1.5” pipe), Antenna Unit
interfaces to a pipe of maximum 1.5” (38.8 mm), measured outer diameter.
Figure 18:
Pole Mount (1.5”
pipe),
Antenna Unit.
