22
VEGA 23:1
English
A
3,5 mm
• Block the roller (
M11
) with the pliers and by pressing on the
spring (
M12
), remove it from its seat. In this way, it will be
possible to remove all the run inversion group.
• Check the condition of each piece, in particular of the gaskets
(
M13
) and the O-ring (
M14
), (
M15
) and (
M16
).
Control that the inner walls of the cylinder are not scratched.
Before reassembling all parts, lubricate them with light and
water proof grease.
• Adjust then the distance (
A
) between the gaskets and the
surface of the piston. This adjustment shall be done with the
cross piece (
M7
) down and it can be better done by using our
special metering device.
After having reassembled all parts, before connecting the
group to the pump, test it by feeding a small quantity of air
(3-4 bar).
•
for a correct reassembly, refer to the pumping group detailed
drawing, by following the disassembly instructions in reverse
order.
M11
M13
M12
M13
M16
M15
M14
Содержание VEGA 23:1
Страница 7: ...5 VEGA 23 1 English H G F WALL BRACKET Version D E ON TANK Version TROLLEY Version B C A ...
Страница 8: ...6 VEGA 23 1 English ...
Страница 26: ...24 VEGA 23 1 English ...
Страница 51: ...49 PAINT SPRAYING EQUIPMENT L innovazione Quella vera ...
