Ediz. 010 - 06/2015
• Lift the suction pipe and replace the product container with
the solvent tank
(ensure it is compatible with the product
being used)
.
• Unscrew the gun nozzle
(remember to clean it with solvent)
.
•
Press the switch (H2) ON and slightly turn the pressure
control knob (H1) clockwise so as the machine works till
the motor starts.
• Make sure the solvent recycles the washing liquid from the
recirculation tube.
• Close the recirculating-safety valve (
H3
).
• Point the gun (
H4
) into the product container (
H5
) and,
keeping the trigger pressed, release the remaining product
till a clean solvent comes out. Now, release the trigger.
H
CLEANING AT THE END OF THE WORK
•
Reduce pressure to the minimum
(turn counterclockwise
the pressure control knob) (
H1
).
•
Press the switch (
H2
) placed on the box of the electric
motor, to stop the equipment.
• Release the residual pressure by holding down the trigger
of the gun and pointing it into a container.
• Open the recirculating-safety valve (
H3
) to release the
pressure in the circuit.
Follow the washing procedure before using again
the equipment.
• Lift again the suction pipe and remove the solvent tank.
• Now point the gun into the solvent tank and press the
trigger so as to recover the residual solvent.
•
As the pump starts idling, press the switch OFF
(0)
to
stop the equipment.
• In case of long storage, we recommend you to suck and
to leave light mineral oil inside the pumping group and the
flexible hose.
SENSORE DI PRESSIONE GUASTO
PRESSURE SENSOR FAULT
DRUCKKNOPFANSCHLUSS DEFEKT
CAPTEUR DE PRESSION EN PANNE
BLOCCO RICIRCOLO (DOPO 15 MIN.)
RECYCLING STOP (AFTER 15 MIN.)
ABSCHALTUNG DES RUCKLAUFS (NACH 15 MIN.)
ARRET RECYCLAGE (APRÈS 15 MIN.)
8
7
MANCANZA CONNESSIONE A TERRA
NO EARTHING
KEINE ERDUNG
PAS DE MISE À TERRE
6
Continuous flashing indicates a lack
of grounding connection while the
machine continues to work.
The operator must, however, immedia-
tely connect the unit to an adequate
grounding system.
LARIUS assumes no responsibility for
failure to comply with this requirement.
ALLARMI - ALARMS
WARNMELDUNGEN - ALARME
LED
www.larius.eu
JOLLY
15
H4
H5
H1
H2
H3
