Lapple FIBRO FIBROTOR EM.NC Series, Руководство по сборке и эксплуатации

Страница: 35 / 60

7 OPERATION
7.1 IMPORTANT SAFETY GUIDELINES
FIBROTOR 35 | 60
7 Operation
7.1
Important safety guidelines
Inadmissible operating parameters / software.
The change of the operating parameters leads to a change in the system behaviour
of the rotating or moving parts of the rotary table. The use of a controller with
unlicensed software creates a risk for the safety of the rotary table. The operating
parameters may be changed only by authorised personnel with detailed knowledge
of the modes of operation and the structure of the rotary table. The use of
unlicensed software is prohibited. Violation of this prohibition can lead to serious
injuries.
In the operation of the rotary table it must be ensured that
•
the rotary table is ready for operation and the operating parameters have been
set up correctly.
•
the operating personnel has been informed prior to starting the rotary table
about the correct behaviour in the event of accidents.
•
the operation is performed only by persons who have been trained, instructed
and authorised for that. These persons must know this manual and proceed
according to it.
•
the rotary table is used / deployed only in accordance with its intended use (see
Chapter 1.2 Intendeduse on page 9).
•
during power-up and operation there is no one in the hazard area of the rotary
table.
•
the operating instructions of the operator are observed.
7.2
Workplaces of the operating personnel
The workplaces of the operating personnel are determined by the operator of the
machine.
7.3
Operating modes
The operating modes can be taken from the specification in the annex.
7.4
Functional sequences
7.4.1
Functional sequence of a dividing movement
Prerequisites:
The table top is in any position.
Electric holding brake energised.
NC control system: Data entry completed