Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and satisfactory
operation of this product. Please retain these instructions for future reference.
Warning
Layout
Specification
Voltage:
240V 50Hz
Lamp:
Max. 1 x 15W LED E27 GLS
IP rating:
44
• Plan the desired layout of this fitting carefully,
ensuring the cables will reach the distance between
the junction box and the light fitting.
• Avoid locating any cables in positions that would
cause a hazard. Position cables and junction boxes
(not supplied) away from areas where they may be
at risk from being cut, trapped or damaged.
• Cables in walls must be protected using suitable
conduit or plastic trunking.
• The mains supply cable must have a minimum cross
sectional area of 1.0mm2.
• This product has special protection against the
ingress of moisture and is IP44 rated.
This product is Double Insulated and does
not require connection to an Earth circuit.
Please read these instructions carefully before
commencing any work.
This unit must be fitted by a competent and qualified
electrician.
Install in accordance with IEE Wiring regulations and
current Building Regulations.
To prevent electrocution switch off at mains supply
before installing or maintaining this fitting. Ensure
other persons cannot restore the electrical supply
without your knowledge. If you are in any doubt,
please consult a qualified electrician.
This light fitting should be connected to a fused
circuit.
If replacing an existing fitting, make a careful note
of the connections.
Always use the correct type and wattage bulb.
Never exceed the wattage stated.
When changing a bulb, always switch off at the
mains and allow the old bulb to cool down before
handling. Dispose of used bulbs carefully and
responsibly.
Waste electrical products should not be disposed of
with household waste. Please recycle where facilities
exist. Check with your local authority or retailer for
recycling advice.
This product is rated at IP44.
The entire unit gets hot whilst on for a period of time.
Existing fittings must be completely removed before
installation of a new product. Before removing the
existing fitting,
carefully note the position of each
set of wires.
• Undo the screw
(1)
at the top and front of the lantern
and remove the cover. Set them aside for refitting later.
• Undo the screw
(2)
from the plastic base under the
lampholder to remove the plastic base and set them
aside for refit. Hold the rear plate in place and mark
the position of the holes. Ensure that the product
is level. Ensure the wall is capable of holding the
weight of the product. Take care to avoid damaging
any concealed wiring and pipes. The correct
fixings should be used for brick, cavity walls or
plasterboard.
• Pull supply wires through rubber grommet on wall
back then fix the wall back to the wall using screws
(3)
and plugs
(4)
.
• Wire as detailed overleaf.
• Refit the plastic cover over the terminal block and
secure in place using the screw.
• Fit the bulb
(5)
(Never fit bulbs of a higher wattage
than those specified on the label as these may
cause over heating and damage the fitting).
• Refit the screws to fit the lantern cover in place.
• Replace fuse or circuit breaker and switch on.
Your light is now ready for use.
Installation
SFX01-148PG
SFX01-495PG
N
L
1
3
4
5
3
2
