Lantronix WiBox, Руководство пользователя

Страница: 21 / 74

WiBox™ User Guide 21
4
4
:
:
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
a
a
t
t
i
i
o
o
n
n
v
v
i
i
a
a
S
S
e
e
r
r
i
i
a
a
l
l
M
M
o
o
d
d
e
e
o
o
r
r
T
T
e
e
l
l
n
n
e
e
t
t
P
P
o
o
r
r
t
t
As an alternative to DeviceInstaller and Web-Manager, the WiBox unit is configurable
using a terminal program to access the serial port locally. Configure the WiBox so
that it can communicate on a network with serial devices. Using this terminal
program to respond to prompts is referred to as the
Setup Mode
.
The unit’s configuration is stored in nonvolatile memory and is retained without
power. Change the configuration at any time. The unit performs a reset after the
configuration has been changed and stored.
Note: The menus in this section show a typical device. Not all devices
display information in the same manner.
Accessing Setup Mode
To configure the unit through a serial connection:
1. Connect a console terminal or PC running a terminal emulation program to your
unit's serial port. The default serial port settings are 9600 baud, 8 bits, no parity,
1 stop bit, no flow control.
2. Reset the WiBox unit by cycling the unit's power (turning the power off and back
on). Immediately upon resetting the device, enter three lowercase
x
characters
(
xxx
).
Note: The easiest way to enter Setup Mode is to hold down the x key at
the terminal (or emulation) while resetting the unit. This must be done
within three seconds of resetting the WiBox.
3. Upon connection, the following information displays:
Figure 4-1. MAC Address
MAC address 00204AFFFF30
Software version 05.3 (040129) WBX
Press Enter to go into Setup Mode
4. To enter the Setup Mode, press
Enter
within 5 seconds.
Note: Connection fails if Enter is not pressed within 5 seconds.
The configuration settings display, followed by the setup menu options: