Lantronix
SISPM1040-3xxx-L Install Guide
33762 Rev. G
Page
46
of
48
Class I, Division 2 / classe I, division 2
Warning and Caution - Proper Installation and Operation (English)
These devices are open-type devices that are to be installed in an enclosure only accessible with the use of a tool,
suitable for the environment. This equipment is suitable for use in Class I, Division 2, Groups A, B, C, and D or non-
hazardous locations only. WARNING – EXPLOSION HAZARD. DO NOT DISCONNECT WHILE THE CIRCUIT IS LIVE OR
UNLESS THE AREA IS FREE OF IGNITIBLE CONCENTRATIONS.
Avertissement et mise en garde - Installation et fonctionnement corrects (français)
Ces périphériques sont des périphériques de type ouvert qui doivent être installés dans un enceinte uniquement
accessible à l'aide d'un outil, adapté à environnement. Cet équipement peut être utilisé dans la classe I, division 2,
groupes A, B, C, et D ou des emplacements non dangereux seulement. AVERTISSEMENT - RISQUE D'EXPLOSION. NE
PAS SE DÉCONNECTER LORSQUE LE CIRCUIT EST VIVANT OU À MOINS QUE LA ZONE NE SOIT LIBRE DE
CONCENTRATIONS IGNIFIABLES.
High Risk Activities Disclaimer
Components, units, or third-party products used in the product described herein are NOT fault-tolerant and are
NOT designed, manufactured, or intended for use as on-line control equipment in the following hazardous
environments requiring fail-safe controls: the operation of Nuclear Facilities, Aircraft Navigation or Aircraft
Communication Systems, Air Traffic Control, Life Support, or Weapons Systems ("High Risk Activities"). Lantronix
and its supplier(s) specifically disclaim any expressed or implied warranty of fitness for such High Risk Activities.
Cautions and Warnings
Definitions
Cautions
indicate that there is the possibility of poor equipment performance or potential damage to the
equipment.
Warnings
indicate that there is the possibility of injury to person.
Cautions and Warnings appear here and may appear throughout this manual where appropriate. Failure to read
and understand the information identified by this symbol could result in poor equipment performance, damage to
the equipment, or injury to persons.
Cautions
While installing or servicing the power module, wear a grounding device and observe all electrostatic discharge
precautions. Failure to observe this caution could result in damage to, or failure of the power module.
Warnings
Warning
: Do not connect the power module to an external power source before installing it into the chassis. Failure
to observe this warning could result in an electrical shock, even death.
WARNING
: The power module has a provision for grounding. Equipment grounding is vital to ensure safe
operation. The installer must ensure that the power module is properly grounded during and after installation.
Failure to observe this warning could result in an electric shock, even death.
WARNING
: A readily accessible, suitable National Electrical Code (NEC) or local electrical code approved disconnect
device and branch-circuit protector must be part of the building's installed wiring to accommodate permanently
connected equipment. Failure to observe this warning could result in an electric shock, even death.
