Lantronix LTR8T, Руководство по установке

Страница: 15 / 36

LTR-T Installation Guide 9
5. Connect the power cord to the LTR-T. The LTR-T can accept power from
either 110 Vac or 220 Vac outlets directly, therefore, there is no need to use a
voltage adapter.
Warning:
To reduce the risk of electric shock, in countries using an IT
power system or where protective earth ground connection is
not made, the ground conductor of the power cable should be
connected to earth ground.
6. Turn the repeater on. The LTR-T should automatically begin the self-test
procedure, described in the next section, to check the status of the hardware. If no
LEDs come on, refer to the “Testing and Diagnostics” section for troubleshooting
suggestions.
Adding New Network Segments
It is not necessary to remove power to the LTR-T when adding new segments to an
existing network. However, adding or removing an existing connection may disrupt the
transmission of an individual Ethernet packet. It is the intent of the IEEE Ethernet
specification that this be a recoverable error at the software level.
To add a new segment to the LTR-T, simply connect the new segment to the LTR-T port.
If there are no faults on the new segment, the LTR-T will automatically integrate the
segment into the existing network.