Lantronix LTR8T, Руководство по установке

Страница: 13 / 36

LTR-T Installation Guide 7
Cabling Instructions
As you follow these instructions, refer to Figure 3 for an illustration of the LTR-T back
panel. Figure 3 shows the location of the 10BASE-T ports, AUI port, power cord, and
fuse.
Fuse
AC input
95-250V
~
50-60Hz 0.5A T2A/250
This equipment complies with the requirements in Part 15 of FCC Rules for a Class A Computing
and TV reception requiring the operator to take whatever steps necessary to correct the interference.
device. Operation of this equipment in a residential area may cause unacceptable interference to radio
CAUTION
For continued protection agains
risk of fire, replace only wit
same type and ratings of fus
Fabriqué aux Etats-Unis
Made in U.S.A.
Serial
U
L
®
UL 1950
LISTED - 6J40
Equipment
®
LR 89493
IEC 950
geprüfte
Sicherheit
AUI 1 8 7 6 5 4 3 2 1
LTR 8T
MDI-X
MDI-X
MDI
15 pin AUI port
10BASE-T ports
AUI and 10BaseT Status
Figure 3: LTR-T Back and Front Panels
0 1
PWR
COL
STAT
ACT
AUI 1 2 3 4 5 6 7 8
---MODE---
LTR8T
Figure 3: LTR-T Front and Back Panels
WARNING:
During the installation procedure some segments of your
network may be unstable. Individual packets on the attached
segments may be lost when new segments are added.
1. Label the 10BASE-T cables. Make sure each end of every cable is marked with
its LTR-T port number and destination. It is important that cable routing and all
connections to the UTP cables are documented. This information is valuable
during troubleshooting, maintenance, or reconfiguration of your network.