Lantronix LTR16T, Руководство по установке

Страница: 14 / 36

8 LTR-T Installation Guide
2. Connect each 10BASE-T cable to the LTR-T. Make sure the port number on
the LTR-T matches the label on the cable, then insert one end of the cable into the
connector. Connect the other end of the cable to the workstation, host, or network
device. The AUI port and unused UTP ports can be left unconnected if not
needed.
3. AUI attachments: If you wish to use the AUI port as either a connection to a
backbone or as another 10BASE-T port, you will need to attach a transceiver to
the AUI port. Note that an AUI cable may be necessary between the LTR-T’s
AUI port and the transceiver itself. The AUI port can be connected to Thickwire,
Thinwire, or UTP by simply using an LTX-5, LTX-2 or LTX-T, respectively.
To connect the transceiver or AUI cable to the LTR-T, first unlock the slide latch
on the connector by sliding the clip to the right. You may have to slightly loosen
the screws on either side of the connector to move the latch. Next, connect the
transceiver or cable connector to the AUI port of the LTR-T (Figure 4). Finally,
lock the transceiver cable in place by sliding the latch to the left.
95-250V
~
50-60Hz
0.5A
T2A/250
This equipment complies with the requirements in Part 15 of FCC Rules for a Clas
and TV reception requiring the operator to take whatever steps necessary to correct
device. Operation of this equipment in a residential area may cause unacceptable inte
CAUTION
For continued protection again
risk of fire, replace only wi
same type and ratings of fu
Serial #
®
geprˇÔte
Sicherheit
AUI 1
8 7 6 5 4 3 2 1
LTR 8
T
MDI-X
MDI-X
MDI
Figure 4: Connecting the AUI cable to the AUI port
UNLOCK
AUI
Figure 4: Connecting the Transceiver Cable to the AUI Port