Lantronix LSB4, Руководство по установке

Страница: 35 / 91

LSB4 Installation Guide Set-up and Operation
3-7
Introduction
Set-up and
Operation
Connections from Netware Hosts
For PC hosts using Netware, the BRCON utility program is provided with
the LSB4 on a DOS diskette. BRCON enables a PC host to log into or issue
commands to the LSB4.
To use the BRCON utility, a Netware file server connection must be
open, or the NetWare workstation shell program must be running.
Copy the BRCON utility program to the hard disk being used or insert the
LSB4 diskette into the A: drive and type the following command
[Figure 3-10]:
Figure 3-10: BRCON Command
A list of the parameters that can be used with the BRCON command will
be displayed [Figure 3-11].
Figure 3-11: BRCON Command List
LSB4name represents the LSB4 service name. The service name is LSB4_
(underscore) , followed by the last three bytes of port 1Õs hardware ad-
dress. For example, if the hardware address (listed above port 1 on the rear
of the unit) is 00-80-A3-08-02, the service name would be
LSB4_A30802 .
C:> BRCON
Brcon Ver. 1.5
-------------------
brcon list list available switches
brcon <LSB4 name> establish a console connecti
brcon <LSB4 name> reload reload a switch
NOTE