Lantronix
ION002-AD User Guide
33612 Rev B
6
CAUTION
: Copper based media ports, e.g., Twisted Pair (TP) Ethernet, USB, RS232, RS422, RS485, DS1, DS3, Video Coax,
etc., are intended to be connected to intrabuilding (inside plant) link segments that are not subject to lightening transients or
power faults. Copper based media ports, e.g., Twisted Pair (TP) Ethernet, USB, RS232, RS422, RS485, DS1, DS3, Video
Coax, etc., are NOT to be connected to interbuilding (outside plant) link segments that are subject to lightening transients or
power faults. Failure to observe this caution could result in damage to equipment.
2. Installation
ION002-AD installation can involve installing the SICs, powering the Chassis, and grounding the Chassis.
Installing Slide-In Cards
CAUTION
: Wear a grounding device and observe electrostatic discharge precautions when installing slide-in
cards into the dual-slot chassis. Failure to observe this caution could result in damage to the slide-in cards.
Note
: The maximum power delivery capacity for the ION002-AD Dual Slot chassis is 6 Watts.
To install a slide-in-card into the ION002-AD chassis:
1. Refer to the manuals for the slide-in card to ensure that any DIP switches or jumpers on the module’s circuit
board are set correctly for the site installation.
2. Carefully align the slide-in card to the chassis installation guides and slide it fully into the installation slot, as
shown below.
3. Ensure that the slide-in card is firmly seated inside the chassis.
4. Push in and rotate the attached panel fastener screw to secure the slide-in card to the ION002-AD chassis
frame.
5. Repeat steps 1-4 to install a second card.
6. If only one card is being installed in the chassis, it is suggested that the slot Blank (provided) is used to cover
up the unused slot.
